Erection Instructions - Awnings In your own interest we suggest you read the entire instruction before erecting the awning for the first time.
Park the caravan in a level position. Unpack the awning and place it on the ground at the right side of the caravan preferably on a piece of plastic (the ground may be wet and dirty).
First ensure that the awning is correct side out, then feed the channel beading at the back of the awning into the awning channel. Pull the beading through the channel - but be careful not to pull on seams or zips.
Do It Yourself Awning Instructions
Now the frame has to be assembled. It makes it easier if all parts are placed on the ground approximately where they are to be used.
Do not fit the legs to the corners/eaves yet. It is not that difficult - most of the frame parts are marked with numbers, 1 to 1, 2 to2, etc.
Lift the awning canvas once more and hook the centre ridge in the centre caravan bracket. if your model has a centre leg it is now to be assembled to the centre bracket. Then the right rafter is connected to the same centre bracket, and the other end fitted to the corner bracket of the eave bar which together with the eave bar is hooked into the right caravan bracket. Then the right leg is fitted.
Nuimage Awnings 70x5240494902c Instructions / Assembly
Now repeat this operation in the left side. It may be necessary to stretch the telescopic poles a little to make the erecting easier. Always use the first hole in poles with button springs.
On models with canopy the short canopy poles are inserted from the outside through the triangle holes in the front. On models with canopy rafters you pull the canopy rafters through the sewn-in sleeves in the front. Start the mounting in the centre and then go to the right and the left side.
It may be a bit tight, but this is usually because the telescopic's have been stretched too hard. When the complete frame is assembled you have to
Awnings, Patio Covers, Retractable Awnings & Window Awnings
Adjust the straps of the flexible pegging to level out the irregularities of the ground, thus you will always obtain a tight canvas when pegging.
On OBI awnings with combi mudwalling: Mount the rubbers opposite to the desired mudwalling, inside and outside, viz, rubbers to be mounted outside for inside mudwalling and inside for outside mudwalling.
Start pegging at the caravan corners i.e., the inner corners of the awning. Then peg the front corners - watch the direction of the side walls - and stretch well. Finally you peg the side and the front.
Outsunny 8' X 7' Patio Retractable Awning/manual Exterior Sun Shade Deck Window Cover, Beige & Reviews
Now the erecting of the awning is almost finished - only pegging of the mudwall and the triangles at the caravan corners remain to be done.
The factory guarantee against defects in material and workmanship within a period of 12 months from the date of purchase against presentation of a receipt.
Take care of the instruction, which has to be followed. If any of these conditions are ignored, factory warranty will not apply.
How To Replace Carefree Of Colorado Awning Fabric
TREATMENT AND MAINTENANCE The awnings are manufactured of carefully selected materials, but even then you have to treat your awning with care to ensure maximum satisfaction.
The canvas is impregnated in order to make it water-repellent. A brand new tent - or an extremely dry tent - requires some moisture before it is fully water-repellent.
Disclaimer - The information provided on this Website site is offered with no warranty as to the authenticity, suitability or competence of the individual, company or service quoted here in. The Website shall not be liable for any damage or difficulty, direct or indirect, arising from utilization of the information contained within these pages. Thomson T-Line History & Information is not responsible for the content of external website's.
Awntech Full Cassette Manual 168 In Wide X 120 In Projection Black/white Striped Manual Retractable Patio Awning In The Awnings Department At Lowes.com
People Also Ask :
The actual figures will depend on the number, type, and size of awning you choose together with the location in which you live. Costs to install a typical awning. Minimum cost. $100. Maximum cost. $5,000. Average range. $ 1,500 to $3,000. National average.
Attach the end mounting brackets. Measure and mark the location for the end mounting brackets attached to the house. ... Attach the extender to the end mounting brackets. Use the hardware prescribed to attach an extender to each mounting bracket. ... Place the first post base. ... Measure the length of the projection beams. ... Connect the outside projection beams. ...
– Step 1: Frame. Start by making the frame. … – Step 2: Awning Material. The awning material is a 6’x9′ canvas drop cloth. … – Step 3: Slide Canvas Onto Frame. Dry-fit the frame and slide the canvas over the top. … – Step 4: Tack the Canvas to the Frame and Mount the Top Portion. …
On the awning rail,mark the position of the centerlines of the arms. Ensure that the arms will not interfere with any lights,vents or other obtrusions. Using a non-permanent method of marking such as a chalk line,mark a perpendicular line from the awning rail down to the floor line. ... Position and attach the bottom mounting brackets. ...
Harrison Awnings
Post a Comment for "Manual Retractable Awning"