DIVIDERS: Where applicable, dividers were not modeled because the gap between dividers and lites were greater than 3mm. For Solar Heat Gain and Visual Light Transmittance default dividers less than 1" and greater or equal to 1" and default patterns were used for simulations.

GROUP LEADERS: The following group leaders are actual simulated individual products per NFRC 4.2.4. and the NFRC Technical Interpretations where applicable. All remaining individual products' U-factors in the corresponding groups are represented by the group leader's U-factor.

Awning Windows - Awning Window Detail

SPECIALITY PRODUCTS TABLE: The specialty products method allow the manufacturer to determine the overall product SHGC and VT for any glazing option. The center of glass SHGC and/or VT must be determined using WINDOW 5.2. The method gives overall product SHGC and VT indexed on center of glass properties.

Steel Awning Windows

C High Performance Casement Windows

1.1.1. Scope All the vinyl windows of types and sizes shown in the plans and/or called for in this specification shall be as manufactured by MGM INDUSTRIES Hendersonville, Tennessee.

1.2.1. Profiles. Main frame and sash components shall be constructed of extruded, high-impact-resistant and UV–stabilized, rigid polyvinyl chloride (PVC). Main Frame members shall be of multi-chambered design.

1.2.2. Thickness. Typical wall for extruded frame and sash members shall be .062" or as indicated on the individual extrusion die drawings.

Drawing - Awning Window Detail

Designer Aluminium Awning Windows

1.2.3. Fasteners. All screws and fastening devices shall be coated with Zinc or Cadmium in conformance with ASTM B 633-85 (1994) and /or ASTM B 766-86 (1993).

1.2.4. Glass and Glazing. Glass is exterior wet glazed into the sash frame. Vent is crank type, mitered, processed and fusion-welded. Glass shall be overall 3/4 inch thick sealed insulating unit, using warm edge spacer technology.

- Awning Window Detail

1.2.5. Weather-stripping. All window gaps between main frame and sash members shall be weatherstripped to prevent air infiltration. Weather-strip shall be a poly pile type with an integral polyethylene fin and shall conform to AAMA 701-92 and 702-92.

Andersen Awning Casement Window

Parts Of A Window Diagram Of A Window

1.3.1. Screen. All screens shall be a half window type sufficient to cover the opening provided by the vent sash. Screen frames are 5/16 x 3/4 inch roll formed aluminum. Screen fabric shall be 18 x 16 fiberglass mesh. Screens shall conform to ANSI/AAMA 1004-1987.

- Awning Window Detail